Netgear XSM4324FS User Manual - Page 186

M4300 Intelligent Edge Series Fully Managed Stackable Switches 4. Select Switching> VLAN > Advanced > VLAN Trunking Configuration. 5. To specify which interfaces are displayed on the page, select one of the following options: • Select the Unit ID field to display physical port information for the selected unit. • Use LAG to display LAGs only. • Use All to display all physical ports. 6. Use one of the following methods to select an interface: • Use Go To Interface to select an interface by entering its number. • Use Interface to select the interface for which data is to be displayed or configured. 7. In the Switchport Mode list, select one of the following: • Access. This mode is suitable for ports connected to end stations or end users. Access ports participate in only one VLAN. They accept both tagged and untagged packets, but always transmit untagged packets. • Trunk. This mode is intended for ports that are connected to other switches. Trunk ports can participate in multiple VLANs and accept both tagged and untagged packets. • General. This mode enables custom configuration of a port. You configure the general port VLAN attributes, such as membership, PVID, tagging, ingress filter, and so on, using the settings on the Port Configuration page. By default, all ports are initially configured in General mode. • Host. This mode is used for private VLAN configuration. • Promiscuous. This mode is used for private VLAN configuration. 8. Select from the list to configure the Access VLAN ID. This is the access VLAN for the port, and is valid only when the port switchport mode is Access. Configure Switching Information 186 User Manual