Netgear XSM4324FS User Manual - Page 608
Con MAC Binding, Use Rate Limit Conform Data Rate
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 608 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches Valid format is xx:xx:xx:xx:xx:xx. 18. Use Source MAC Mask to specify the Source MAC address mask specifying which bits in the Source MAC to compare against an Ethernet frame. Valid format is xx:xx:xx:xx:xx:xx. 19. Use VLAN to specify the VLAN ID to compare against an Ethernet frame. Valid range of values is 1 to 4095. Either VLAN range or VLAN can be configured. 20. Use Logging to enable or disable logging. When set to Enable, logging is enabled for this ACL rule (subject to resource availability in the device). If the access list trap flag is also enabled, this causes periodic traps to be generated indicating the number of times this rule was hit during the current report interval. A fixed 5 minute report interval is used for the entire system. A trap is not issued if the ACL rule hit count is zero for the current interval. This field is only supported for a Deny action. 21. Use Rate Limit Conform Data Rate to specify the value of the conforming data rate of MAC ACL rule. Valid values are 1 to 4294967295 in Kbps. 22. Use Rate Limit Burst Size to specify the burst size of MAC ACL rule. Valid values are 1 to 128 in Kbytes. 23. Use Time Range to enter the name of the time range associated with the MAC ACL rule. The Rule Status displays if the ACL rule is active or inactive. If this field is blank, no timer schedules are assigned to the rule. 24. Click the Apply button. Your settings are saved. Configure MAC Binding When an ACL is bound to an interface, all the rules that are defined are applied to the selected interface. Use the MAC Binding Configuration page to assign MAC ACL lists to ACL priorities and interfaces. To configure MAC binding: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. Manage Switch Security 608 User Manual