Netgear XSM4324FS User Manual - Page 169

M4300 Intelligent Edge Series Fully Managed Stackable Switches The valid range is 100 to 500. 7. Click the Apply button. Your settings are saved. Configure a Stack Member To configure a stack member before adding it to the stack: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select System > Stacking > Stack Configuration. 5. Select the Unit ID of the stack member to add. 6. Select the switch model number of the new unit from the Switch Type field. 7. Optionally, specify the Switch Priority to select whether this unit becomes a management unit in preference to another unit. The default value for this setting is undefined. If the preference level is set to zero, then the device cannot become a management unit. A higher value indicates a higher priority. The maximum value is 15. 8. Use the Management Status field to indicate whether the selected switch is the stack master, a normal stacking member, or the standby unit. A standby unit takes over the stack master responsibilities if the stack master becomes unavailable. 9. Click the Add button. The preconfigured unit is added to the stack. Manage Stacking 169 User Manual