Netgear XSM4324FS User Manual - Page 580

M4300 Intelligent Edge Series Fully Managed Stackable Switches Table 210. IP Source Guard Dynamic Binding Configuration (continued) Field IP Address Filter Type Description Displays valid IP address for the binding entry. Filter type used on the interface. One is source IP address filter type, and the other is source IP address and MAC address filter type. Configure IPv6 Source Guard Interface Settings To configure IPv6 source guard Interface settings: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select Security > Control > IPv6 Source Guard > Interface Configuration. 5. Use one of the following methods to select an interface: • In the Go To Interface field, enter the interface in the unit/slot/port format and click on the Go button. • Next to the Interface column, select the check box for the port that you want to configure, select multiple check boxes to apply the same setting to all selected interfaces, or select the check box in the table heading to apply the same settings to all interfaces. 6. Use the IPv6SG Mode menu to enable or disable validation of sender IPv6 address on this interface. If IPv6SG is enabled, packets are not forwarded if the sender IPv6 address is not in the DHCP snooping binding database. The factory default is Disable. Manage Switch Security 580 User Manual