Netgear XSM4324FS User Manual - Page 88

M4300 Intelligent Edge Series Fully Managed Stackable Switches 5. From the Interface menu, select the interface. 6. Use the EEE Admin Mode selection to enable or disable Energy Efficient Ethernet Admin Mode on the port. With EEE mode enabled, the port transitions to low power mode during a link idle condition. The default value is Disabled. If EEE Admin Mode is not supported, then N/A is displayed. 7. In the EEE Transmit Wake Time field, enter the time for which MAC/switch must wait to go back to active state from LPI state when it receives a packet for transmission. The range is 8 to 65535. The default value is 17. 8. Click the Apply button. Your settings are saved. The following table describes the nonconfigurable fields. Table 28. Green Ethernet Local Device information Field Description Cumulative Energy Saved on this Cumulative energy saved due to all green modes enabled on this port in port due to Green mode(s) (Watts (Watts * Hours). * Hours) Rx Low Power Idle Event Count This field is incremented each time MAC RX enters low-power idle (LPI) state. Shows the total number of Rx LPI events since EEE counters were last cleared. Rx Low Power Idle Duration (uSec) This field indicates duration of Rx LPI state in 10 us increments. Shows the total duration of Rx LPI since the EEE counters were last cleared. Tx Low Power Idle Event Count This field is incremented each time MAC TX enters LPI state. Shows the total number of Tx LPI events since EEE counters were last cleared. Tx Low Power Idle Duration (uSec) This field indicates duration of Tx LPI state in 10 us increments. Shows the total duration of Tx LPI since the EEE counters were last cleared. Tw_sys_tx (uSec) Integer that indicates the value of Tw_sys that the local system can support. Tw_sys_tx Echo (uSec) Integer that indicates the remote system's Transmit Tw_sys that was used by the local system to compute the Tw_sys that it wants to request from the remote system. Tw_sys_rx (uSec) Integer that indicates the value of Tw_sys that the local system requests from the remote system. Tw_sys_rx Echo (uSec) Integer that indicates the remote system's Receive Tw_sys that was used by the local system to compute the Tw_sys that it can support. Fallback Tw_sys (uSec) Integer that indicates the value of fallback Tw_sys that the local system requests from the remote system. Tx_dll_enabled Data Link Layer Enabled: Initialization status of the EEE transmit Data Link Layer management function on the local system. Tx_dll_ready Data Link Layer ready: This variable indicates that the tx system initialization is complete and is ready to update/receive LLDPDU containing EEE TLV. Configure System Information 88 User Manual