Netgear XSM4324FS User Manual - Page 214

M4300 Intelligent Edge Series Fully Managed Stackable Switches Note: For two bridges to be in the same region, the force version must be 802.1s and their configuration name, digest key, and revision level must match. For additional information about regions and their effect on network topology, refer to the IEEE 802.1Q standard. Configure Basic STP Settings To configure STP basic settings: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select Switching > STP > Basic > STP Configuration. 5. Select the Spanning Tree Admin Mode Disable or Enable radio button. This specifies whether spanning tree operation is enabled on the switch. 6. Use Force Protocol Version to specify the Force Protocol Version parameter for the switch. Configure Switching Information 214 User Manual