Netgear XSM4324FS User Manual - Page 396

M4300 Intelligent Edge Series Fully Managed Stackable Switches The area is returned to the normal state. The following table describes the nonconfigurable information that is displayed. Table 142. Advanced OSPFv3 Common Area Configuration Field External Routing SPF Runs Area Border Router Count Area LSA Count Area LSA Checksum Import Summary LSAs Description A definition of the router's capabilities for the area, including whether or not AS-external-LSAs are flooded into or throughout the area. The number of times that the intra-area route table was calculated using this area's link state database. This is done using Dijkstra's algorithm. The total number of area border routers reachable within this area. This is initially zero, and is calculated in each SPF pass. The total number of link state advertisements in this area's link state database, excluding AS external LSAs. The 32-bit unsigned sum of the link state advertisements' LSA checksums contained in this area's link state database. This sum excludes external (LSA type 5) link state advertisements. The sum can be used to determine if there was a change in a router's link state database, and to compare the link state database of two routers. The summary LSAs are enabled or disabled imported into this area. Configure an OSPFv3 Stub Area To configure the OSPFv3 stub area: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select Routing > OSPFv3 > Advanced > Stub Area Configuration. Configure OSPF and OSPFv3 396 User Manual