Netgear XSM4324FS User Manual - Page 461

M4300 Intelligent Edge Series Fully Managed Stackable Switches 11. Enter the Startup Query Count value to indicate the configured number of queries sent out on startup, separated by the startup query interval. The default value is 2. 12. In the Last Member Query Interval field, enter the last member query interval in milliseconds. This is the maximum response time to be inserted into group-specific queries sent in response to leave group messages, and is also the amount of time between group-specific query messages. Valid values are from 0 to 655355. The default value is 1000 milliseconds. 13. In the Last Member Query Count field, enter the number of queries to be sent on receiving a leave group report. Valid values are from 1 to 20. The default value is 2. 14. Click the Apply button. Your settings are saved. The following table describes the nonconfigurable information that is displayed. Table 176. IPv6 MLD Routing Interface Configuration Field Operational Mode Robustness Description The operational status of MLD on the Interface. The robustness parameter for the selected interface. This variable allows tuning for the expected packet loss on a subnet. If a subnet is expected to be lossy, the robustness variable can be increased. MLD is robust to robustness variable -1 packet losses. The default value is 2. View IPv6 MLD Routing Interface Statistics To view the IPv6 multicast MLD routing interface statistics: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select Routing> IPv6 Multicast > MLD > Routing Interface Statistics. Configure Multicast Routing 461 User Manual