Netgear XSM4324FS User Manual - Page 672

M4300 Intelligent Edge Series Fully Managed Stackable Switches The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select Maintenance > Save Config > Auto Install Configuration. The Autoinstall State field displays the current status of the Autoinstall process. 5. From the AutoInstall Mode menu, select the start/stop auto install mode on the switch. 6. From the AutoInstall Persistent Mode menu, enable or disable the AutoInstall persistent mode. 7. From the AutoSave Mode menu, select Enabled or Disabled. 8. From the AutoInstall Retry Count menu, specify the number of times the unicast TFTP tries are made for the DHCP specified file before falling back for broadcast TFTP tries. 9. Click the Apply button. Your settings are saved. If you restart the switch, the saved settings are retained. Reset the Switch to Its Factory Default Settings Note: If you reset the switch to the default configuration, the IP address is reset to 169.254.100.100, and the DHCP client is enabled. The IP address of the OOB port is set to 192.168.0.239. To reset the switch to the factory default settings: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. Maintenance and Troubleshooting 672 User Manual