Netgear XSM4324FS User Manual - Page 387

M4300 Intelligent Edge Series Fully Managed Stackable Switches 4. Select Routing > OSPF > Advanced > Route Redistribution. 5. From the Source menu, select from the list of available source routes that were not previously configured for redistribution by OSPF. The valid values are as follows: • BGP • Connected • OSPF • RIP • Static 6. In the Redistribute list, select to Enable or Disable the redistribution for the selected source protocol. 7. Set the Metric value to be used as the metric of redistributed routes. This fields displays the metric if the source was preconfigured and can be modified. The valid values are 0 to 16777214. 8. From the Metric Type list, select the OSPF metric type of redistributed routes. 9. Set the Tag field in routes redistributed. This field displays the tag if the source was preconfigured; otherwise, the tag is 0 and can be modified. The valid values are 0 to 4294967295. 10. From the Subnets list, select whether the subnetted routes will be redistributed (Enable) or not (Disable). 11. In the Distribute List field, set the access list that filters the routes to be redistributed by the destination protocol. Only permitted routes are redistributed. If this command refers to a nonexistent access list, all routes are permitted. The valid values for access list IDs are 1 to 199. When used for route filtering, the only fields in an access list that get used are as follows: • Source IP address and netmask • Destination IP address and netmask • Action (permit or deny) All other fields (source and destination port, precedence, ToS, and so on) are ignored. Configure OSPF and OSPFv3 387 User Manual