Netgear XSM4324FS User Manual - Page 443

M4300 Intelligent Edge Series Fully Managed Stackable Switches • Next to the Interface column, select the check box for the interface that you want to configure. 6. In the Admin Mode field, select the Enable or Disable option to set the administrative status of PIM in the router. The default is Disable. 7. In the Hello Interval field, enter the time in seconds between the transmission of PIM hello messages on this interface. The valid values are from 0 to 18000. The default value is 30. 8. In the Join/Prune Interval, enter the time in seconds at which PIM Join/Prune messages are transmitted on this PIM interface. The valid values are from 0 to 18000. The default value is 60. 9. In the BSR Border field, select the Enable or Disable option to set the bootstrap router (BSR) border status on the selected interface. 10. Enter the DR Priority for the selected interface. The valid values are from 0 to 2147483647. The default value is 1. 11. Click the Apply button. Your settings are saved. The following table describes the nonconfigurable information that is displayed. Table 167. Multicast PIM Interface Configuration Field Protocol State IP Address Designated Router Neighbor Count Description The state of PIM in the router. either Operational or Non-Operational. The IP address of the selected PIM interface. If you enter an IPv6 address, the format is prefix/prefix length. The designated router on the selected PIM interface. The number of PIM neighbors on the selected interface. View the PIM Neighbor To view the PIM neighbor: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. Configure Multicast Routing 443 User Manual