Netgear XSM4324FS User Manual - Page 643

M4300 Intelligent Edge Series Fully Managed Stackable Switches Table 223. EAP Statistics Field EAP Response Frames Received EAP Request/ID Frames Transmitted EAP Request Frames Transmitted Description This displays the number of valid EAP response frames (other than resp/ID frames) that were received by this authenticator. This displays the number of EAP request/identity frames that were transmitted by this authenticator. This displays the number of EAP request frames (other than request/identity frames) that were transmitted by this authenticator. Perform a Cable Test To perform a cable test: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select Monitoring > Ports > Cable Test. 5. Use one of the following methods to select a port: • In the Go To Port field, enter the interface in the unit/slot/port format and click on the Go button. • Next to the Port column, select the check box for the port that you want to test. 6. Click the Apply button. A cable test is performed on the selected interface. The cable test might take up to two seconds to complete. If the port has an active link, the cable status is always Normal. The Monitor the Switch and Network 643 User Manual