Netgear XSM4324FS User Manual - Page 144

M4300 Intelligent Edge Series Fully Managed Stackable Switches Table 49. LLDP Remote Device Inventory (continued) Field System Name Remote Port ID Description Specifies model name of the remote device. The port component associated with the remote system. Configure LLDP-MED Global Settings You can specify LLDP-MED parameters that are applied to the switch. To configure LLDP-MED global settings: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select System > LLDP > LLDP-MED > Global Configuration. 5. In the Fast Start Repeat Count field, enter the number of LLDP PDUs that are transmitted when the protocol is enabled. The range is from (1 to 10). Default value of fast repeat count is 3. The Device Class field specifies local device's MED classification. There are four different kinds of devices, three of them represent the actual end points (classified as Class I Generic [IP Communication Controller and so on], Class II Media [Conference Bridge and so on], Class III Communication [IP Telephone and so on]). The fourth device is Network Connectivity Device, which is typically a LAN Switch/Router, IEEE 802.1 Bridge, IEEE 802.11 Wireless Access Point and so on. 6. Click the Apply button. Your settings are saved. Configure System Information 144 User Manual