Netgear XSM4324FS User Manual - Page 441

M4300 Intelligent Edge Series Fully Managed Stackable Switches The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select Routing> Multicast > PIM > Global Configuration. 5. In the Admin Mode field, select the protocol of PIM in the router. Possible values are Disable, PIM-SM, or PIM-DM. The default is Disable. 6. Click the Apply button. Your settings are saved. Configure PIM SSM Settings While PIM employs a specially configured rendezvous point (RP) router that serves as a meeting junction for multicast senders and listeners, Protocol-Independent Multicast Single-Source Multicast (PIM-SSM) does not use an RP. It supports only source route delivery trees. It is used between routers so that they can track which multicast packets to forward to each other and to their directly connected LANs. The SSM service model can be implemented with a strict subset of the PIM protocol mechanisms. Both regular IP multicast and SSM semantics can coexist on a single router, and both can be implemented using the PIM protocol. A range of multicast addresses, currently 232.0.0.0/8 in IPv4 and FF3x::/32 in IPv6, is reserved for SSM. To configure PIM SSM settings: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select Routing> Multicast > PIM > SSM Configuration. Configure Multicast Routing 441 User Manual