Netgear XSM4324FS User Manual - Page 199

M4300 Intelligent Edge Series Fully Managed Stackable Switches This is enabled only when VLAN ID or dot1p is selected as the interface mode. 9. In the CoS Override Mode field, select Disable or Enable. The default is Disable. 10. In the Authentication Mode field, select Enable or Disable. The default is Enable. When the authentication mode is enabled, voice traffic is allowed on an unauthorized voice VLAN port. When the authentication mode is disabled, devices are authorized through dot1x. Note: Authentication through dot1x is possible only if dot1x is enabled. 11. In the DSCP Value field, configure the Voice VLAN DSCP value for the port. The valid range is 0 to 64. The default value is 0. The Operational State field displays the operational status of the voice VLAN on the interface. 12. Click the Apply button. Your settings are saved. Configure GARP Switch Settings Note: It can take up to 10 seconds for GARP configuration changes to take effect. To configure GARP switch settings: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select Switching> VLAN > Advanced > GARP Switch Configuration. Configure Switching Information 199 User Manual