Netgear XSM4324FS User Manual - Page 693

M4300 Intelligent Edge Series Fully Managed Stackable Switches The default value is 0. The range is 0 to 39936. The size you enter is not retained across a power cycle. 13. Enter the Source IP address or interface to use when sending the echo request packets. If source is not required, select None as the source option. Possible values are as follows: • None. The source address of the ping packet would be the address of the default outgoing interface. • IP Address. The source IP address to use when sending the echo request packets. This field is shown when IP Address is selected as the source option. • Interface. The interface to use when sending the echo request packets. This field is shown when Interface is selected as the source option. Note: Values configured in the fields on this page are not saved to the switch. As a result, refreshing the page sets these fields to the default values. 14. Click the Apply button. The traceroute begins. The results display in the TraceRoute area. The Results field displays the traceroute IPv6 result after the switch sends a traceroute request to the specified IP address or host name. Capture Packets You can capture and store packets on a USB flash storage device. To initiate packet capturing: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select Maintenance > Troubleshooting > Packet Capturing. Maintenance and Troubleshooting 693 User Manual