Netgear XSM4324FS User Manual - Page 685

M4300 Intelligent Edge Series Fully Managed Stackable Switches 5. Use Unit to select the unit ID whose code image to activate, update, or delete. 6. Use Next Active Image to make the selected image the next active image for subsequent reboots of this unit. 7. Use Image Description to specify the description for the image that you selected. 8. Click the Apply button. Your settings are saved. Note: After activating an image, you must perform a system reset of the switch to run the new image. The following table describes the nonconfigurable information displayed on the page. Table 230. Dual Image Configuration Field Image Name Active Image Version Description This displays the image name for the selected unit. The current active image of the selected unit. The version of the image1 code file. Troubleshooting You can send a ping, trace a route, and perform a memory dump. Ping an IPv4 Address You can tell the switch to send a ping request to a specified IP address. You can check whether the switch can communicate with a particular IP station. When you click the Apply button, the switch sends a specified number of ping requests and the results are displayed. Maintenance and Troubleshooting 685 User Manual