Netgear XSM4324FS User Manual - Page 67
Source Interface, Unicast Poll Interval, Time Zone Name, Offset Hours, Offset, Minutes, Routing VLAN
View all Netgear XSM4324FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
M4300 Intelligent Edge Series Fully Managed Stackable Switches The default value is Unicast. 6. In the Port field, specify the local UDP port that the SNTP client receives server packets on. The allowed range is 1025 to 65535 and the value 123. The default value is 123. When the default value is configured, the actual client port value used in SNTP packets is assigned by the operating system. 7. Select the Source Interface to use for the SNTP client. Possible values are as follows: • None • VLAN 1 • Routing interface • Routing VLAN • Routing loopback interface • Tunnel interface • Service port By default VLAN 1 is used as the source interface. 8. Specify the Unicast Poll Interval. This is the number of seconds between unicast poll requests expressed as a power of two when configured in unicast mode. The allowed range is 6 to 10. The default value is 6. 9. Specify the Broadcast Poll Interval. This is the number of seconds between broadcast poll requests expressed as a power of 2 when configured in broadcast mode. Broadcasts received prior to the expiry of this interval are discarded. The allowed range is 6 to 10. The default value is 6. 10. Specify the Unicast Poll Timeout. This is the number of seconds to wait for an SNTP response when configured in unicast mode. The allowed range is 1 to 30. The default value is 5. 11. Specify the Unicast Poll Retry. This is the number of times to retry a request to an SNTP server after the first time-out before attempting to use the next configured server when configured in unicast mode. The allowed range is 0 to 10. The default value is 1. 12. Use the Time Zone Name field to configure a time zone specifying the number of hours and, optionally, the number of minutes difference from UTC with Offset Hours and Offset Minutes. The time zone can affect the display of the current system time. The default value is UTC. When using SNTP/NTP time servers to update the switch's clock, the time data received from the server is based on Coordinated Universal Time (UTC), which is the same as Greenwich Mean Time (GMT). This might not be the time zone in which the switch is located. Configure System Information 67 User Manual