Netgear XSM4324FS User Manual - Page 233

M4300 Intelligent Edge Series Fully Managed Stackable Switches 7. The Per VLAN Cost is the path cost from the port to the root bridge. The values allowed are between 1 and 200,000,000. By default, cost is not configured. Use the value 0 to unconfigure the setting. If per VLAN cost is not configured, the path cost value is set based on Link Speed. 8. Click the Apply button. Your settings are saved. The following table describes the nonconfigurable information that the PVST/RPVST Interface Configuration page displays. Table 84. PVST/RPVST Interface Configuration Field Interface Role Status Description The list of physical interfaces and LAGs. Indicates the role of the interface. Possible values are as follows: Disabled, Root, Designated, Alternate, Backup, and Master. Note: The blank field is displayed for the interface which is not included for the specified VLAN. Indicates the status of the interface. Possible values are as follows: Discarding, Learning, Forwarding, and Disabled. Note: The blank field is displayed for the interface which is not included for the specified VLAN. View PVST Statistics You can view and configure Per VLAN Spanning Tree Protocol (PVST)/Per VLAN Rapid Spanning Tree Protocol (RPVST) Statistics settings for the device. To view the PVST/RPVST statistics: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select Switching > STP > Advanced > PVST Statistics. Configure Switching Information 233 User Manual