Netgear XSM4324FS User Manual - Page 420

M4300 Intelligent Edge Series Fully Managed Stackable Switches Table 152. Multicast Mroute Table (continued) Field Incoming Interface Outgoing Interfaces Up Time (hh:mm:ss) Expiry Time (hh:mm:ss) RPF Neighbor Protocol Flags Description The incoming interface on which multicast packets for this source/group arrive. The list of outgoing interfaces on which multicast packets for this source/group are forwarded. The time in seconds since the entry was created. The time in seconds before this entry ages out and is removed from the table. The IP address of the reverse path forwarding (RPF) neighbor. The multicast routing protocol which created this entry. The possible values are as follows: • PIM-DM • PIM-SM • DVMRP The value displayed in this field is valid if the multicast routing protocol running is PIM-SM. The possible values are RPT or SPT. For other protocols a "------" is displayed. Add Mroute Static Multicast Entries You can add static multicast route (Mroute) entries to the Mroute table. To add static multicast entries to the Mroute table: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select Routing > Multicast > Mroute Static-Multicast Configuration. Configure Multicast Routing 420 User Manual