Netgear XSM4324FS User Manual - Page 303

M4300 Intelligent Edge Series Fully Managed Stackable Switches By default, the rate limit is 100 packets/sec (the burst interval is 1000 msec). To disable ICMP Rate limiting, set this field to 0. The valid rate Interval is from 0 to 2147483647. 9. Use ICMP Rate Limit Burst Size to control the ICMP error packets by specifying the number of ICMP error packets that are allowed per burst interval. By default, burst size is 100 packets. When the burst interval is 0, then configuring this field is not a valid operation. The valid burst size range is 1 to 200. 10. Use Select to configure Global Default Gateway to edit the Global Default Gateway field. 11. Use Global Default Gateway to set the global default gateway to the manually configured value. A default gateway configured with this command is more preferred than a default gateway learned from a DHCP server. Only one default gateway can be configured. If you invoke this command multiple times, each command replaces the previous value. 12. Click the Apply button. Your settings are saved. The following table describes the nonconfigurable information displayed on the page. Table 107. Routing IP Configuration Field Default Time to Live Maximum Next Hops Maximum Routes Description The default value inserted into the Time-To-Live field of the IP header of datagrams originated by the switch, if a TTL value is not supplied by the transport layer protocol. The maximum number of hops supported by the switch. This is a compile-time constant. The maximum number of routes (routing table size) supported by the switch. This is a compile-time constant. View Statistics The statistics reported on this page are as specified in RFC 1213. To view statistics: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select Routing> IP > Basic > Statistics. Manage Routing 303 User Manual