Netgear XSM4324FS User Manual - Page 281

M4300 Intelligent Edge Series Fully Managed Stackable Switches algorithm, excellent load balancing performance, and packet attributes selection based on the packet type: • For L2 packets, source and destination MAC address are used for hash computation. • For L3 packets, source IP, destination IP address, TCP/UDP ports are used. 8. Use STP Mode to enable or disable the Spanning Tree Protocol administrative mode associated with the LAG. The possible values are as follows: • Disable. Spanning tree is disabled for this LAG. • Enable. Spanning tree is enabled for this LAG. Enable is the default. 9. Use Static Mode to select Enable or Disable. When the LAG is enabled, it does not transmit or process received LACPDUs that is, the member ports do not transmit LACPDUs and all the LACPDUs it can receive are dropped. The factory default is Disable. 10. Use Link Trap to specify whether to send a trap when the link status changes. The factory default is Enable, which causes the trap to be sent. 11. Use Local Preference Mode to Enable or Disable the LAG interface's local preference mode. The default is Disable. 12. Click the Apply button. Your settings are saved. The following table describes the nonconfigurable information displayed on the page. Table 101. LAG Configuration Field LAG Description LAG ID LAG State Configured Ports Active Ports Description Enter the description string to be attached to a LAG. It can be up to 64 characters in length. Identification of the LAG. Indicates whether the link is up or down. Indicate the ports that are members of this port-channel Indicates the ports that are actively participating in the port-channel. Configure Switching Information 281 User Manual