Netgear XSM4324FS User Manual - Page 359

M4300 Intelligent Edge Series Fully Managed Stackable Switches Configure OSPF Configure Basic OSPF Settings To configure basic OSPF settings: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select Routing > OSPF > Basic > OSPF Configuration. 5. Select the Admin Mode Disable or Enable radio button. If you select Enable, OSPF is activated for the switch. By default, OSPF is enabled. You must configure a router ID before OSPF can become operational. Use the IP Configuration page to configure a router ID or issue the config router id CLI command. For more information, see Configure the Routing IP Settings on page 302. The Router ID displays the 32-bit integer in dotted-decimal format that uniquely identifies the router within the autonomous system (AS). To change the router ID, you must first disable OSPF. After you set the new router ID, you must reenable OSPF for the change to take effect. The default value is 0.0.0.0, although this is not a valid router ID. 6. Click the Apply button. Your settings are saved. Configure OSPF and OSPFv3 359 User Manual