Netgear XSM4324FS User Manual - Page 328

M4300 Intelligent Edge Series Fully Managed Stackable Switches example, 2001:231F:::1. Then click the Go button. If the address exists, that entry is displayed. An exact match is required. • To search by Interface, select Interface from the Search By list, enter the interface ID in unit/slot/port format, for example, 2/1/1. Then click the Go button. If the address exists, that entry is displayed. 6. To refresh the page with the latest information on the switch, click the Refresh button. 7. To clear the IPv6 neighbors on a selected interface or on all interfaces, click the Clear button. The following table describes the nonconfigurable information that is displayed. Table 117. IPv6 Advanced Neighbor Table Field Interface IPv6 Address MAC Address isRtr Neighbor State Last Updated Description The interface whose settings are displayed in the current table row. The IPv6 address of the neighbor or interface. Specifies MAC address associated with an interface. Indicates whether the neighbor is a router. If the neighbor is a router, the value is True. If the neighbor is not a router, the value is False. The state of the neighbor cache entry. Following are the states for dynamic entries in the IPv6 neighbor discovery cache: • Incmp. Address resolution is being performed on the entry.A neighbor solicitation message was sent to the solicited-node multicast address of the target, but the corresponding neighbor advertisement message has not yet been received. • Reach. Positive confirmation was received within the last Reachable Time milliseconds that the forward path to the neighbor was functioning properly. While in REACH state, the device takes no special action as packets are sent. • Stale. More than ReachableTime milliseconds elapsed since the last positive confirmation was received that the forward path was functioning properly. While in STALE state, the device takes no action until a packet is sent. • Delay. More than ReachableTime milliseconds elapsed since the last positive confirmation was received that the forward path was functioning properly. A packet was sent within the last DELAY_FIRST_PROBE_TIME seconds. If no reachability confirmation is received within DELAY_FIRST_PROBE_TIME seconds of entering the DELAY state, send a neighbor solicitation message and change the state to PROBE. • Probe. A reachability confirmation is actively sought by resending neighbor solicitation messages every RetransTimer milliseconds until a reachability confirmation is received. Time since the address was confirmed to be reachable. Manage Routing 328 User Manual