Netgear XSM4324FS User Manual - Page 412

M4300 Intelligent Edge Series Fully Managed Stackable Switches The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select Routing > OSPFv3 > Advanced > Virtual Link Configuration. 5. Enter the Area ID of the OSPF area. An area ID is a 32-bit integer in dotted-decimal format that uniquely identifies the area to which a router interface connects. Virtual links can be configured between any pair of area border routers with interfaces to a common (non-backbone) area. 6. Configure the Neighbor Router ID by entering the neighbor portion of a virtual link specification. Virtual links can be configured between any pair of area border routers having interfaces to a common (non-backbone) area. 7. In the Hello Interval field, enter the OSPFv3 hello interval for the specified interface in seconds. This parameter must be the same for all routers attached to a network. The valid values range from 1 to 65,535. The default is 10 seconds. 8. In the Dead Interval field, enter the OSPFv3 dead interval for the specified interface in seconds. This specifies how long a router waits to see a neighbor router's hello packets before declaring that the router is down. This parameter must be the same for all routers attached to a network. This value is a multiple of the hello interval (for example, 4). The valid values range from 1 to 65,535. The default is 40. 9. In the Iftransit Delay Interval field, enter the OSPFv3 transit delay for the specified interface. This specifies the estimated number of seconds it takes to transmit a link state update packet over the selected interface. The valid values range from 1 to 3600 seconds (1 hour). The default value is 1 second. 10. In the Retransmit Interval field, enter the OSPFv3 retransmit interval for the specified interface. This is the number of seconds between link state advertisements for adjacencies belonging to this router interface. This value is also used when retransmitting database descriptions and link state request packets. The valid values range from 1 to 3600 seconds (1 hour). The default is 5 seconds. 11. Click the Add button The new virtual link is added to the switch. Configure OSPF and OSPFv3 412 User Manual