Netgear XSM4324FS User Manual - Page 604

M4300 Intelligent Edge Series Fully Managed Stackable Switches Traffic rule applies either to inbound traffic only or to outbound traffic only. 12. From the Unit 1 and LAG switch figures onscreen, select the ports and LAGs to which the rule must apply. If a port or LAG is not selected, click the port or LAG to select it. If a port or LAG is selected, click the port or LAG to clear it again. 13. Click the Add button. The rule is added to the ACL based on the destination MAC address. 14. Click the Apply button. Your settings are saved. Use the ACL Wizard to Complete the Destination MAC ACL For information about the ACL Wizard, see Use the ACL Wizard to Create a Simple ACL on page 600. To complete the destination MAC ACL using ACL wizard, you must do the following: 1. Select the destination MAC ACL as ACL type. 2. Enter the DMAC VLAN as the ACL Rule. 3. To select the direction and ports to bind the ACL, in the Directions field, select the packet filtering direction for an ACL. The options are Inbound or Outbound. The Port Selection Table specifies the list of all available valid interfaces for ACL mapping. All non-routing physical interfaces and interfaces participating in LAG are listed. Configure a Basic MAC ACL A MAC ACL consists of a set of rules which are matched sequentially against a packet. When a packet meets the match criteria of a rule, the specified rule action (Permit/Deny) is taken, and the additional rules are not checked for a match. Rules for the MAC ACL are specified/created using the MAC ACL Rule Configuration page. Multiple steps are involved in defining a MAC ACL and applying it to the switch: 1. Create the ACL Name. 2. Create rules for the ACL. 3. Assign the ACL by its name to a port. For information about how to view the configurations, see View and Delete MAC ACL Bindings in the MAC Binding Table on page 610. Manage Switch Security 604 User Manual