Netgear XSM4324FS User Manual - Page 52

M4300 Intelligent Edge Series Fully Managed Stackable Switches The System Information page displays. 4. Select System > Management > Management Interfaces > IPv4 Service Port Configuration. 5. Select a Service Port Configuration Protocol radio button: • BootP. During the next boot cycle, the BootP client on the device broadcasts a BootP request in an attempt to acquire information from a BootP server on the network. • DHCP. During the next boot cycle, the DHCP client on the device broadcasts a DHCP request in an attempt to acquire information from a DHCP server on the network. • None. The device does not attempt to acquire network information dynamically. • This specifies how the device acquires network information on the service port. 6. In the IP Address field, specify the IP address of the interface. • If the service port configuration protocol is None, you can manually configure a static IP address. • If the service port configuration protocol is BootP or DHCP, this field displays the IP address that was dynamically acquired (if any). 7. In the Subnet Mask field, specify the IP subnet mask for the interface: • If the service port configuration protocol is None, you can manually configure a static subnet mask. • If the service port configuration protocol is BootP or DHCP, this field displays the subnet mask that was dynamically acquired (if any). 8. In the Default Gateway field, specify the default gateway for the IP interface: • If the Service Port Configuration Protocol is None, you can manually configure the IP address of the default gateway. • If the Service Port Configuration Protocol is BootP or DHCP, this field displays the default gateway address that was dynamically acquired (if any). 9. Click the Apply button. Your settings are saved. Configure System Information 52 User Manual