Netgear XSM4324FS User Manual - Page 686

M4300 Intelligent Edge Series Fully Managed Stackable Switches If a reply to the ping is not received, the following message displays: Tx = Count, Rx = 0 Min/Max/Avg RTT = 0/0/0 msec If a reply to the ping is received, the following message displays: Reply From a.b.c.d: icmp_seq = 0. time= xyz usec. Reply From a.b.c.d: icmp_seq = 1. time= abc usec. Reply From a.b.c.d: icmp_seq = 2. time= def usec. Tx = count, Rx = count Min/Max/Avg RTT = xyz/abc/def msec To configure the settings and ping a host on the network: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select Maintenance > Troubleshooting > Ping IPv4. 5. Use IP Address/Host Name to enter the IP address or host name of the station for the switch to ping. The initial value is blank. 6. In the Count field, enter the number of echo requests to send. The default value is 3. The range is 1 to 15. 7. Enter the Interval between ping packets in seconds. The default value is 3 seconds. The range is 1 to 60. Maintenance and Troubleshooting 686 User Manual