Netgear XSM4324FS User Manual - Page 653

M4300 Intelligent Edge Series Fully Managed Stackable Switches This resets all statistics for the trap logs to the default values. The following table describes the Trap Log information displayed on the page. Table 226. Trap Logs Field Description Number of Traps Since Last The number of traps that occurred since the switch last rebooted. Reset Trap Log Capacity The maximum number of traps stored in the log. If the number of traps exceeds the capacity, the entries overwrite the oldest entries. Number of Traps since log last viewed The number of traps that occurred since the traps were last displayed. Displaying the traps by any method (terminal interface display, web display, upload file from switch, and so on) causes this counter to be cleared to 0. Log The sequence number of this trap. System Up Time The time when this trap occurred, expressed in days, hours, minutes and seconds, since the last reboot of the switch. Trap Information identifying the trap. View and Clear the Event Log You can view and clear the event log, which contains error messages from the system. The event log is not cleared on a system reset. To view and clear the event log: 1. Launch a web browser. 2. In the address field of your web browser, enter the IP address of the switch. The login window opens. 3. Enter admin as the user name, enter your local device password, and click the Login button. The first time that you log in, no password is required. However, you then must specify a local device password to use each subsequent time that you log in. The System Information page displays. 4. Select Monitoring > Logs > Event Logs. Monitor the Switch and Network 653 User Manual