Netgear XCM8806 Chassis Hardware Installation Guide - Page 1041

NETGEAR 8800 Chassis Switch CLI Manual Usage Guidelines This command is used to enable the OSPFv3 protocol on all IPv6 configured VLANs or all IPv6 tunnels. The instance ID is used to control the selection of other routers as neighbors. The router will become a neighbor only with routers that have the same instance ID. An interface can have only one instance ID associated with it in one OSPFv3 domain. However, the same interface can be associated with another OSPFv3 domain with a different instance ID. An interface associated with two OSPFv3 domains cannot have same instance ID. To change the instance ID associated with an interface, you must first remove the interface from the OSPFv3 area and then add it back with a different instance ID. The passive parameter indicates that the router only synchronizes and listens, and does not originate or send any new information on the interface. Example The following command enables OSPFv3 on all IPv6 tunnels: configure ospfv3 add tunnel all area 0.0.0.1 configure ospfv3 add virtual-link configure ospfv3 {domain } add virtual-link {routerid} {area} Description Adds a virtual link connected to another ABR. Syntax Description domainName router-identifier area-identifier Specifies an OSPFv3 domain. OSPF-Default is the only one currently supported. Specifies the router ID of the other end of the link. Specifies the transit area identifier, a four-byte, dotted decimal number. Default N/A. Usage Guidelines A virtual link provides a logical path between the ABR of the disconnected area and the ABR of the normal area that connects to the backbone. A virtual link must be established between two ABRs that have a common area, with one ABR connected to the backbone. Specify the following: • router-identifier-Far-end router identifier, a four-byte, dotted decimal number. Chapter 24. OSPFv3 Commands | 1041