Netgear XCM8806 Chassis Hardware Installation Guide - Page 668

NETGEAR 8800 Chassis Switch CLI Manual show vlan blue security The following is sample output from this command: Port 24 Limit State Learned Unlimited Unlocked 0 Blackholed Locked 0 0 ssh2 ssh2 {cipher [3des | blowfish]} {port } {compression [on | off]} {user } {@} [ | ] {} {vr } Description Initiates an SSH2 client session to a remote SSH2 server. Syntax Description 3des blowfish portnum on off username host ipaddress remote command vr_name Specifies that the 3des cipher should be used for encryption. This is the default. Specifies that the blowfish cipher should be used for encryption. Specifies the TCP port number to be used for communicating with the SSH2 client. The default is port 22. Specifies that the data is to be compressed. Specifies that compression is not to be used. This is the default. Specifies a login name for the remote host, as an alternate to the username@host parameter. Can be omitted if it is the same as the username on the switch. Specifies the name of the remote host. Specifies the IP address of the remote host. Specifies a command to be passed to the remote system for execution. The switch does not support remote commands. The option is only valid if the remote system is a system, such as a UNIX workstation, that accepts remote commands. Specifies the virtual router. The default virtual router is VR-Mgmt. Note: User-created VRs are supported only on the platforms listed for this feature in Appendix A in the NETGEAR 8800 User Manual. Default The default settings for SSH2 parameters are as follows: • cipher-3des encryption • port-22 • compression-off • vr_name-VR-Mgmt 668 | Chapter 15. Security Commands