Netgear XCM8806 Chassis Hardware Installation Guide - Page 1146
enable bgp neighbor soft-in-reset, If no address family is specified, IPv4 unicast is the default.
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1146 highlights
NETGEAR 8800 Chassis Switch CLI Manual • The remote AS does not have officially allocated AS numbers. • You want to conserve AS numbers if you are multi-homed to the local AS. Private AS numbers should not be advertised on the Internet. Private AS numbers can only be used locally within an administrative domain. Therefore, when routes are advertised out to the Internet, the routes can be stripped out from the AS paths of the advertised routes using this feature. Example The following command enables the removal of private AS numbers from the AS path in route updates sent to the EBGP peers: enable bgp neighbor 192.168.1.17 remove-private-AS-numbers enable bgp neighbor soft-in-reset enable bgp neighbor [all | ] {address-family [ipv4-unicast | ipv4-multicast]} soft-in-reset Description Enables the soft input reset feature. Syntax Description all remoteaddr address-family Specifies all neighbors. Specifies an IP address of a BGP neighbor. The address family. BGP supports two address families: IPv4 Unicast and IPv4 Multicast. Default Disabled. If no address family is specified, IPv4 unicast is the default. Usage Guidelines Disabling the soft input reset feature can potentially limit the amount of system memory consumed by the RIB-in. This command can be issued only when both BGP and the BGP neighbor is disabled. Example The following command enables the soft recognition feature: enable bgp neighbor 192.168.1.17 soft-in-reset 1146 | Chapter 25. BGP Commands