Netgear XCM8806 Chassis Hardware Installation Guide - Page 258

NETGEAR 8800 Chassis Switch CLI Manual (L3_L4) Layer 3 address and Layer 4 port based (custom) User-selected address-based configuration Custom Algorithm Configuration: ipv4 source-only, xor Note - Layer 4 ports are not used for distribution for traffic ingressing MSM-G8X I/O ports and ports on G48T, G48P, G24X, and 10G4X modules. - The 'custom' algorithm is not used for traffic ingressing on current slot 1, 2, 3, 5 and 10. Refer to XOS Command Reference. Number of load sharing trunks: 3 show port transceiver information show port transceiver information Description Displays basic information about the optical transceiver. Syntax Description port-list Specifies the port number(s). Default N/A. Usage Guidelines Digital Diagnostic Monitoring Interface (DDMI) provides critical system information about 10G XFP optical modules. Use this command to monitor the condition of the XFP modules. If you try to execute this command on one of the ports in the port list that is non-compliant with DDMI, the following error message is displayed and the command does not go through: Port 3:1 This command is not supported on this port. All ports and transceiver of the ports requested in the command need to support DDMI. If you try to execute this command on one of the ports in the port list on which the transceiver is non-compliant with DDMI, the following error message is displayed: Port 3:1 This media/transceiver does not support enhanced digital diagnostic monitoring interface (DDMI). All ports and transceiver of the ports requested in the command need to support DDMI. For more detailed information, use the show port transceiver information detail command. Example The following display shows output for the command show port 1:1-2 transceiver information: BD-8810.2 # sh port 1:1-2 transceiver information 258 | Chapter 5. Commands for Configuring Slots and Ports on a Switch