Netgear XCM8806 Chassis Hardware Installation Guide - Page 172

NETGEAR 8800 Chassis Switch CLI Manual Local Filename Character Restrictions This section provides information about the characters supported by the switch for local filenames. When specifying a local filename, the switch permits only the following characters: • Alphabetical letters, upper case and lower case (A-Z, a-z) • Numerals (0-9) • Period ( . ) • Dash ( - ) • Underscore ( _ ) When naming a local or remote file, remember the requirements listed above. Internal Memory Card and Core Dump Files When you delete a core dump file from the system, that file is unavailable. When you configure the switch to send core dump (debug) information to the internal memory card, specify the internal-memory option to remove/delete the specified core dump file. For information about configuring and sending core dump information to the internal memory card, see the configure debug core-dumps and save debug tracefiles memorycard commands. You can use the * wildcard to delete core dump files from the internal memory card. If you configure the switch to write core dump files to the internal memory card and attempt to download a new software image, you might have insufficient space to complete the image download. When this occurs, you must decide whether to continue the software download or move or delete the core dump files from the internal memory. For example, if your switch has an external memory card installed with space available, transfer the files to the external memory card. Transfer the files from the internal memory card to a TFTP server. This frees up space on the internal memory card while keeping the core dump files. This command also replicates the action from the primary MSM/MM to the backup MSM/MM. For example, when you delete a file on the primary MSM/MM, the same file on the backup MSM/MM is deleted. For the memorycard option, this command removes/deletes an existing file on the card, including core dump files if configured. See the section "Internal Memory Card and Core Dump Files" for information about core dump files. You can use the * wildcard to delete all of a particular file type from the external memory card; currently running and in use files are not deleted. Example The following command removes the configuration file named Activeb91.cfg from the system: rm Activeb91.cfg 172 | Chapter 4. Commands for Managing the NETGEAR 8800 Software