Netgear XCM8806 Chassis Hardware Installation Guide - Page 155

NETGEAR 8800 Chassis Switch CLI Manual tftp get 10.1.2.3 vr "VR-Mgmt" test.pol memory-card august23.pol The following command retrieves the configuration file named meg-upload.cfg from a TFTP server with an IP address of 10.10.10.10: tftp get 10.10.10.10 vr "VR-Mgmt" meg_upload.cfg tftp put tftp put [ | ] {-vr } [{[internal-memory | memorycard | } {} | {} {[internal-memory | memorycard | ]}] Description Allows you to use TFTP from the current command line interface session to copy the file from the local host, including the switch, internal memory card, or external compact flash card and put it on a TFTP server. Syntax Description host-name ip-address vr_name internal-memory local-file-internal memorycard local-file-memcard local_file remote_file Specifies the name of the remote host. Specifies the IP address of the TFTP server. Specifies the name of the virtual router. Note: User-created VRs are supported only on the platforms listed for this feature in Appendix A of the NETGEAR 8800 User Manual. Specifies the internal memory card. Specifies the name of the core dump file located on the internal memory card. Specifies the removable external compact flash card. Specifies the name of the file on the external compact flash card. Specifies the name of the file (configuration file, policy file) on the local host. Specifies the name of the file on the remote host. Default If you do not specify a virtual router, VR-Mgmt is used. Usage Guidelines NetASCII and mail file type formats are not supported. This command was introduced to simplify using TFTP to transfer configuration, policy, and if configured, core dump files from the switch to the TFTP server. You can continue to use the original TFTP command. Chapter 3. Commands for Managing the Switch | 155