Netgear XCM8806 Chassis Hardware Installation Guide - Page 1286
enable msdp process-sa-request, specified
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1286 highlights
NETGEAR 8800 Chassis Switch CLI Manual Usage Guidelines You must use this command to administratively enable the MSDP peers before they can establish peering sessions and start exchanging SA messages. Example The following command enables an MSDP peer: enable msdp peer 192.168.45.43 enable msdp process-sa-request enable msdp [{peer} | peer all] process-sa-request {sa-request-filter } {vr } Description This command configures MSDP to receive and process SA request messages from a specified peer or all peers. If an SA request filter is specified, only SA request messages from those groups permitted are accepted. All others are ignored. Syntax Description filter-name peer all remoteaddr vrname Specifies the name of the policy filter associated with SA request processing. Specifies all MSDP peers. Specifies the IP address of the MSDP peer. Specifies the name of the virtual router to which this command applies. If a name is not specified, it is extracted from the current CLI context. Default By default, all SA request messages are accepted from peers. Usage Guidelines Use this command to configure the router to accept all or just some SA request messages from peers. If no policy is specified, all SA request messages are accepted. If a policy is specified, only SA request messages from those groups permitted are accepted, and all others are ignored. You cannot change an SA request filter while SA request processing is enabled for an MSDP peer. You must first disable SA request processing for a peer and then re-enable it with an SA request filter. You can use the following policy attributes in an SA request policy. All other attributes are ignored. • Match: 1286 | Chapter 28. MSDP Commands