Netgear XCM8806 Chassis Hardware Installation Guide - Page 1197
con pim state-refresh timer origination-interval
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1197 highlights
NETGEAR 8800 Chassis Switch CLI Manual Usage Guidelines When this feature is disabled on an interface, the interface behaves as follows: • State refresh messages are not originated. • State refresh messages received on the interface are dropped without processing. • State refresh messages received on other interfaces are not forwarded to the disabled interface. Example The following command enables the PIM-DM state refresh feature on VLAN blue: configure pim state-refresh blue on configure pim state-refresh timer origination-interval configure pim state-refresh timer origination-interval Description Configures the interval at which state refresh messages are originated. Syntax Description interval Specifies a refresh interval in seconds. The range is 30 to 90 seconds. Default 60 seconds. Usage Guidelines None. Example The following command configures the interval to 45 seconds: configure pim state-refresh timer origination-interval 45 configure pim state-refresh timer source-active-timer configure pim state-refresh timer source-active-timer Description Defines how long a multicast source (S,G) is considered active after a packet is received from the source. Chapter 26. IP Multicast Commands | 1197