Netgear XCM8806 Chassis Hardware Installation Guide - Page 786
recommends that you specify the identifying keyword as well as the name. If you do
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 786 highlights
NETGEAR 8800 Chassis Switch CLI Manual • Restricted role (enabled, disabled) • MSTP port role (internal or boundary) To display more detailed information for one or more ports in the specified STPD, including participating VLANs, specify the detail option. If you have MSTP configured and specify the detail option, this command displays additional information: • MSTP internal path cost • MSTP timers If your STPD has the same name as another component, for example a VLAN, NETGEAR recommends that you specify the identifying keyword as well as the name. If you do not specify the stpd keyword, an error message similar to the following is displayed: %% Ambiguous command: "show Test ports" In this example, to view all of the port settings of STPD Test, enter show stpd Test ports. If your STPD has a name unique only to that STPD, the keyword stpd is optional. Example The following command displays the state of slot 3, ports 1 through 3 on an STPD named s0: show stpd S0 ports 3:1-3:3 The following is sample output from this command: Port Mode State Cost Flags Priority Port ID Designated Bridge 3:1 802.1D FORWARDING 100 e------- 16 16641 00:00:00:00:00:00:00:00 3:1 802.1D BLOCKING 20000 eApp-w---r 128 8001 10:00:00:04:96:26:5f:47 3:2 802.1D FORWARDING 100 e------- 16 16642 00:00:00:00:00:00:00:00 3:2 802.1D FORWARDING 20000 eRppaw---- 128 8003 10:00:00:04:96:26:5f:47 3:3 802.1D FORWARDING 100 e------- 16 16643 00:00:00:00:00:00:00:00 3:3 802.1D FORWARDING 20000 eDpp-w---- 128 8004 20:00:00:04:96:26:5c:48 Total Ports: 3 Flags 1: e=Enable, d=Disable 2: (Port role) R=Root, D=Designated, A=Alternate, B=Backup, M=Master 3: (Config type) b=broadcast, p=point-to-point, e=edge, a=auto 4: (Oper. type) b=broadcast, p=point-to-point, e=edge 5: p=proposing, a=agree 6: (partner mode) d = 802.1d, w = 802.1w, m = mstp 7: i = edgeport inconsistency 8: S = edgeport safe guard active s = edgeport safe guard configured but inactive 9: B = Boundary, I = Internal 10: r = Restricted Role 786 | Chapter 17. STP Commands