Netgear XCM8806 Chassis Hardware Installation Guide - Page 799

NETGEAR 8800 Chassis Switch CLI Manual Default Authentication is set to none. Usage Guidelines This command can add a modest amount of security to VRRP advertisements. All VRRP routers using the same VRID must use the same password when using this feature. A simple password must be between 1 and 8 characters long. Example The following command configures authentication for VRRP VLAN vrrp-1 with the password newvrrp: configure vrrp vlan vrrp-1 vrid 1 authentication simple-password newvrrp configure vrrp vlan vrid delete configure vrrp vlan vrid delete Description Deletes a virtual IP address from a specific VRRP virtual router. Syntax Description vlan_name vridval ipaddress Specifies the name of a VRRP VLAN. Specifies a VRRP Virtual Router ID (VRID). Value can be in the range of 1-255. Specifies the IP address of the virtual router in which this device participates. Usage Guidelines The restrictions on this command are as follows: • If the priority of the VR is 255, the IP address to be added must be owned by the VLAN on which the VR exists. If the priority is not 255, the IP address must not be owned by that VLAN. • When a VR is enabled, it must have at least one virtual IP address. When the VR is not enabled, there are no restrictions on deleting the IP address. Example The following command removes IP address 10.1.2.3 from VLAN vlan-1: configure vrrp vlan vlan-1 vrid 1 delete 10.1.2.3 Chapter 18. VRRP Commands | 799