Netgear XCM8806 Chassis Hardware Installation Guide - Page 344
having a configurable severity level for each target.
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 344 highlights
NETGEAR 8800 Chassis Switch CLI Manual console memory-buffer primary-msm primary-node backup-msm backup-node nvram session syslog all ipaddress ipPort vr_name local0 ... local7 filter-name severity only Specifies the console display. Specifies the switch memory buffer. Specifies the primary MSM. Specifies the primary node in a stack. Specifies the backup MSM. Specifies the backup node in a stack. Specifies the switch NVRAM. Specifies the current session (including console display). Specifies a syslog remote server. Specifies all of the syslog remote servers. Specifies the syslog IP address. Specifies the UDP port number for the syslog target. Specifies the virtual router that can reach the server IP address. Note: User-created VRs are supported only on the platforms listed for this feature in Appendix A in the NETGEAR 8800 User Manual. Specifies the local syslog facility. Specifies the filter to associate with the target. Specifies the minimum severity level to send (if the keyword only is omitted). Specifies that only the specified severity level is to be sent. Default If severity is not specified, the severity level for the target is left unchanged. If a virtual router is not specified, VR-Mgmt is used. Usage Guidelines This command associates the specified filter and severity with the specified target. A filter limits messages sent to a target. Although each target can be configured with its own filter, by default, all targets are associated with the built-in filter, DefaultFilter. Each target can also be configured with its own severity level. This provides the ability to associate multiple targets with the same filter, while having a configurable severity level for each target. A message is sent to a target if the target has been enabled, the message passes the associated filter, the message is at least as severe as the configured severity level, and the message output matches the regular expression specified. By default, the memory buffer, NVRAM, primary MSM/MM, and backup MSM/MM targets are enabled. For other targets, use 344 | Chapter 8. Commands for Status Monitoring and Statistics