Netgear XCM8806 Chassis Hardware Installation Guide - Page 62
con snmp access-profile
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
NETGEAR 8800 Chassis Switch CLI Manual To resume using automatic power supply management on a PSU, use the configure power supply auto command. The setting for each PSU is stored as part of the switch configuration. To display power supply status and power budget information use the show power and show power budget commands. Example The following command configures the PSU in slot 1 to be forced on when either 110V AC or 220V AC power input is present, overriding automatic power management: configure power supply 1 on The switch displays the following message: In a mixed environment of 110V and 220V AC inputs, power management may automatically disable 110V supplies to maximize the system power budget. By specifying 'on', you wish to override power management and enable the specified power supply. This may cause the system power budget to decrease and one or more I/O cards may be powered off as a result. Are you sure you want to continue? (y/n) Enter y to continue. configure snmp access-profile configure snmp access-profile [ | none] {readonly | readwrite} Description Configures SNMP to use an ACL policy for access control. Syntax Description profile_name none readonly readwrite Configures SNMP to use an ACL policy. Cancels a previously configured ACL policy. Specifies read-only access to the system. Specifies read and write access to the system. Default SNMP access is enabled by default, with no ACL policies. Usage Guidelines You must be logged in as administrator to configure SNMP parameters. 62 | Chapter 3. Commands for Managing the Switch