Netgear XCM8806 Chassis Hardware Installation Guide - Page 161

NETGEAR 8800 Chassis Switch CLI Manual When you configure and enable the switch to send core dump (debug) information to the internal memory card, specify the internal-memory option and associated internal-memory name options to copy an existing core dump file. If your switch has an external compact clash memory card installed, you can copy the core dump file to that card. For information about configuring and sending core dump information to the internal memory card, see the configure debug core-dumps and save debug tracefiles memorycard commands. For more detailed information about core dump files, see Appendix D in the NETGEAR 8800 User Manual. This command also replicates the action from the primary MSM/MM to the backup MSM/MM. For example, when you copy a file on the primary MSM, the same file is copied to the backup MSM/MM. For the memorycard option, the source and/or destination is the memorycard. You must mount the memory card for this operation to succeed. The cp command copies a file from the switch to the external memory card or a file already on the card. If you copy a file from the switch to the external memory card, and the new filename is identical to the source file, you do not need to re-enter the filename. When you send core dump information to the external memory card, specify the memorycard option and associated memorycard name options to copy an existing core dump file. Example The following command makes a copy of a configuration file named test.cfg and gives the copied file a new name of test_rev2.cfg: cp test.cfg test_rev2.cfg The following command makes a copy of a configuration file named primary.cfg from the switch to an external memory card with the same name, primary.cfg: cp primary.cfg memorycard The above command performs the same action as entering the following command: cp primary.cfg memorycard primary.cfg disable cpu-monitoring disable cpu-monitoring Description Disables CPU monitoring on the switch. Command Syntax This command has no arguments or variables. Chapter 4. Commands for Managing the NETGEAR 8800 Software | 161