Netgear XCM8806 Chassis Hardware Installation Guide - Page 1130
disable bgp neighbor capability
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1130 highlights
NETGEAR 8800 Chassis Switch CLI Manual Default Disabled. Usage Guidelines After the session has been disabled, all the information in the route information base (RIB) for the neighbor is flushed. Example The following command disables the BGP session: disable bgp neighbor 192.1.1.17 disable bgp neighbor capability disable bgp neighbor [all | ] capability [ipv4-unicast | ipv4-multicast | route-refresh] Description This command disables BGP Multiprotocol (MP) and route-refresh capabilities for neighbor. Syntax Description all remoteaddr ipv4-unicast ipv4-multicast route-refresh Specifies all neighbors. Specifies an IP address of the BGP neighbor. Specifies BGP MP unicast capabilities. Specifies BGP MP multicast capabilities. Specifies ROUTE-REFRESH message capabilities. Default All capabilities are enabled by default. Usage Guidelines Note: This command is not generally supported, and is not recommended for general use. However, to inter-operate with Cisco routers for BGP graceful restart, you must enable IPv4 unicast address capability. 1130 | Chapter 25. BGP Commands