Netgear XCM8806 Chassis Hardware Installation Guide - Page 824
con iparp delete, con iparp delete proxy
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 824 highlights
NETGEAR 8800 Chassis Switch CLI Manual • The source IP address is not on the same subnet as the target address (unless the always flag is set). After all the proxy ARP conditions have been met, the switch formulates an ARP response using the configured MAC address in the packet. The default maximum number of proxy entries is 256, but can be increased to 4096 by using the following command: configure iparp max_proxy_entries {vr } Example The following command configures the switch to answer ARP requests for all devices with the address range of 100.101.45.1 to 100.101.45.255: configure iparp add proxy 100.101.45.0/24 configure iparp delete configure iparp delete {vr } Description Deletes an entry from the ARP table. Specify the IP address of the entry to delete. Syntax Description ip_addr vr_name Specifies an IP address. Specifies a VR name. Default If you do not specify a virtual router, the current virtual router context is used. Usage Guidelines Removes any IP ARP entry (dynamic or permanent) from the table. Example The following command deletes an IP address entry from the ARP table: configure iparp delete 10.1.2.5 configure iparp delete proxy configure iparp delete proxy [[ | {}] {vr } | all] 824 | Chapter 19. IP Unicast Commands