Netgear XCM8806 Chassis Hardware Installation Guide - Page 231
enable slot, The XCM8848T, XCM8824F, and XCM8808X I/O modules forward unicast traffic
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 231 highlights
NETGEAR 8800 Chassis Switch CLI Manual • On the 8800 original-series modules, these packets are transmitted on a single port of a LAG. • On the 8800, these packets are distributed across all members of a LAG. The distribution of these packets depends on the type of the traffic. Broadcast, L2 multicast and unknown unicast traffic distribution is based on the source and destination MAC addresses. IP multicast traffic distribution is based on the source and destination IP addresses. This behavior is not configurable. • The custom keyword is supported only on NETGEAR 8800 switches. If the custom keyword is specified on a NETGEAR 8800 switch that includes a mix of 8800 series modules, the individual modules use algorithms as follows: • The XCM8848T, XCM8824F, and XCM8808X I/O modules forward unicast traffic using the L3 algorithm. • All other modules forward unicast traffic using the L3_L4 algorithm. • All modules forward non-unicast traffic (broadcast, multicast, and unknown unicast packets) using a separate internal hash algorithm. Example The following example defines a static link aggregation group (LAG) on a switch that contains ports 9 through 12 on slot 3, ports 7 through 10 on slot 5, and uses the first port on slot 3 as the logical port 9: enable sharing 3:9 grouping 3:9-3:12, 5:7-5:10 In this example, logical port 3:9 represents physical ports 3:9 through 3:12 and 5:7 through 5:10. The following example defines a dynamic LAG on a stand-alone switch containing ports 10 through 15, with port 10 being the logical port: enable sharing 10 grouping 10-15 lacp The following example selects the custom option on a NETGEAR 8800 switch: XCM8810.1 # enable sharing 2:1 grouping 2:1-2 algorithm address-based custom The following example defines a health check LAG containing ports 10 through 13 with port 10 as the master logical port and specifies address-based link aggregation by Layer 3 IP plus Layer 4 port: enable sharing 10 grouping 10,11,12,13 algorithm address L3_L4 health-check To configure a health-check LAG, refer to the configure sharing health-check member-port add tcp-tracking command. enable slot enable slot Description Enables slots. Chapter 5. Commands for Configuring Slots and Ports on a Switch | 231