Netgear XCM8806 Chassis Hardware Installation Guide - Page 337

NETGEAR 8800 Chassis Switch CLI Manual The following command configures the system log to maintain a running real-time display of only log messages of critical severity: configure log display critical only configure log filter events configure log filter [add | delete] {exclude} events [ | [all | ] {severity {only}}] Description Configures a log filter to add or delete detailed feature messages based on a specified set of events. In a stack, this command is applicable only to Master and Backup nodes and not applicable to the standby nodes. Syntax Description name add delete exclude event-condition all event-component severity only Specifies the filter to configure. Add the specified events to the filter Remove the specified events from the filter Events matching the specified events will be excluded Specifies an individual event. Specifies all components and subcomponents. Specifies all the events associated with a particular component. Specifies the minimum severity level of events (if the keyword only is omitted). Specifies only events of the specified severity level. Default If the exclude keyword is not used, the events will be included by the filter. If severity is not specified, then the filter will use the component default severity threshold (see the note on page 338 when delete or exclude is specified). Usage Guidelines This command controls the incidents that pass a filter by adding, or deleting, a specified set of events. If you want to configure a filter to include or exclude incidents based on event parameter values (for example, MAC address or BGP Neighbor) see the command configure log filter events match on page 340. Chapter 8. Commands for Status Monitoring and Statistics | 337