Netgear XCM8806 Chassis Hardware Installation Guide - Page 55
Example, Description, traceroute
![]() |
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
NETGEAR 8800 Chassis Switch CLI Manual Example The following command displays current switch information: show switch Output from this command looks similar to the following: SysName: SysLocation: SysContact: System MAC: System Type: BD-8810Rack3 00:04:96:1D:00:C0 BD-8810 SysHealth check: Recovery Mode: System Watchdog: Enabled (Normal) All Enabled Current Time: Timezone: Boot Time: Boot Count: Next Reboot: System UpTime: Fri Feb 13 02:25:24 1925 [Auto DST Disabled] GMT Offset: 0 minutes, name is UTC. Wed Feb 11 21:39:56 1925 159 None scheduled 1 day 4 hours 45 minutes 28 seconds Slot: Current State: MSM-A MASTER MSM-B BACKUP (In Sync) Image Selected: Image Booted: Primary ver: Secondary ver: secondary primary 12.0.0.4 12.0.0.4 secondary primary 12.0.0.4 12.0.0.4 Config Selected: primary.cfg Config Booted: primary.cfg primary.cfg primary.cfg primary.cfg Created by NETGEAR 8800 version 11.6.0.30 574246 bytes saved on Wed Jul 30 19:39:55 1924 The show switch detail command displays the same information shown above. traceroute traceroute {vr } {ipv4 } {ipv6 } {ttl } {from } {[port ] | icmp} Description Enables you to trace the routed path between the switch and a destination endstation. Chapter 2. Commands for Accessing the Switch | 55
![](/manual_guide/products/netgear-xcm8806-chassis-hardware-installation-guide-da290e3/55.png)