Netgear XCM8806 Chassis Hardware Installation Guide - Page 1271
con msdp peer sa-limit
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1271 highlights
NETGEAR 8800 Chassis Switch CLI Manual Default By default, no SA filter is configured for an MSDP peer. That is, incoming and outgoing SA messages are not filtered. Usage Guidelines This command configures an SA filter such that only a specified set of SA messages are accepted or sent to a peer. Note that an SA filter does not adversely impact the flow of SA request and response messages. To remove an SA filter, enter the "none" CLI keyword for . You can use the following policy attributes in an SA filter policy. All other attributes are ignored. • Match: • multicast-group • multicast-source • pim-rp • Set: • permit • deny Example The following command configures an incoming SA messages filter on an MSDP peer with the IP address 192.168.45.43: configure msdp peer 192.168.45.43 sa-filter in allow_229 configure msdp peer sa-limit configure msdp peer [ | all] sa-limit {vr } Description This command allows you to limit the number of SA entries from an MSDP peer that the router will allow in the SA cache. To allow an unlimited number of SA entries, use 0 (zero) as the value for . Syntax Description max-sa peer all remoteaddr Specifies the maximum number of SA entries from an MSDP peer allowed in the SA cache. To specify an unlimited number of SA entries, use 0 (zero) as the value for . Specifies all MSDP peers. Specifies the IP address of the MSDP peer. Chapter 28. MSDP Commands | 1271