Netgear XCM8806 Chassis Hardware Installation Guide - Page 832
con iproute delete
View all Netgear XCM8806 Chassis manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 832 highlights
NETGEAR 8800 Chassis Switch CLI Manual Default If no metric is specified, the default metric of 1 is used. If you do not specify a virtual router, the current virtual router context is used. Usage Guidelines Default routes are used when the router has no other dynamic or static route to the requested destination. A default gateway must be located on a configured IP interface. Use the unicast-only or multicast-only options to specify a particular traffic type. If not specified, both unicast and multicast traffic uses the default route. Example The following command configures a default route for the switch: configure iproute add default 123.45.67.1 configure iproute delete configure iproute delete [ | ] {multicast | multicast-only | unicast | unicast-only} {vr } Description Deletes a static address from the routing table. Syntax Description ipNetmask ipaddress mask gateway multicast multicast-only unicast unicast-only vrname Specifies an IP address/mask length. Specifies an IP address. Specifies a subnet mask. Specifies a VLAN gateway. Specifies a multicast route to delete. Specifies a multicast route to delete. Specifies a unicast route to delete. Specifies a unicast route to delete. Specifies the virtual router to which the route is deleted. Default If you do not specify a virtual router, the current virtual router context is used. Usage Guidelines Use a value of 255.255.255.255 or /32 for mask to indicate a host entry. 832 | Chapter 19. IP Unicast Commands