Netgear XCM8806 Chassis Hardware Installation Guide - Page 159

NETGEAR 8800 Chassis Switch CLI Manual Description Copies an existing configuration, policy, or if configured, core dump file stored in the system. Syntax Description internal-memory old-name-internal new-name-internal memorycard old-name-memorycard new-name-memorycard old-name new-name Specifies the internal memory card. Specifies the name of the core dump file located on the internal memory card that you want to copy. Specifies the name of the newly copied core dump file located on the internal memory card. Specifies the removable external compact flash memory card. Specifies the name of the file located on the external compact flash memory card that you want to copy. Depending on your switch configuration, you can have configuration, policy, or core dump files stored in this card. Specifies the name of the newly copied file located on the external compact flash memory card. Specifies the name of the configuration or policy file that you want to copy. Specifies the name of the newly copied configuration or policy file. Default N/A. Usage Guidelines Use this command to make a copy of an existing file before you alter or edit the file. By making a copy, you can easily go back to the original file if needed. When you copy a configuration or policy file, remember the following: • XML-formatted configuration files have a .cfg file extension. The switch only runs .cfg files. • ASCII-formatted configuration files have a .xsf file extension. For more information, see Appendix B in the NETGEAR 8800 User Manual. • Policy files have a .pol file extension. • Core dump files have a .gz file extension. See "Internal Memory and Core Dump Files" below. When you copy a configuration or policy file from the system, make sure you specify the appropriate file extension. For example, when you want to copy a policy file, specify the filename and .pol. When you copy a file on the switch, the switch displays a message similar to the following: Copy config test.cfg to config test1.cfg on switch? (y/n) Chapter 4. Commands for Managing the NETGEAR 8800 Software | 159